NEW TESTING CENTRE FOR PINTSCH BUBENZER BRAKES


2020-9-9

Source:PINTSCH BUBENZER USA LLC

https://pintschbubenzer.de/corporate-news/new-testing-centre-for-pintsch-bubenzer-brakes/


NEW TESTING CENTRE FOR PINTSCH BUBENZER BRAKES

Brake products supplied by Pintsch Bubenzer USA will be tested by two new dynamometer test stands at the manufacturer’s research and development centre in Betzdorf, Germany.


Pintsch Bubenzer makes high performance disc and drum brakes for cranes and other severe duty applications, as well as complementary products, such as emergency and storm brakes. One test bench is used for smaller caliper and drum brakes and the other for larger caliper and hydraulic brakes.


The testing facility is particularly applicable to products supplied in the USA to Association for Iron & Steel Technology (AIST) – formerly Association of Iron and Steel Engineers (AISE) – standards and those that meet the rigid requirements of Deutsches Institut für Normung e.V. (DIN), the German national organisation for standardisation.


As Joel Cox, president at Pintsch Bubenzer USA explained, products for wind energy and storm brakes are subject to more specific testing as they do not always rely on ‘spinning’ as much as ‘grabbing’.


Cox added, “Our goal was to not only build a testing centre that could work with today’s highest capacity equipment, but also tomorrow’s. Given the pace of evolution – we recently installed a series of Twin Safe TS800 brakes on two 10,000t  [22 million pound] capacity cranes and auxiliary hoists aboard a giant semi-submersible crane vessel—that vision required us to think big. To have a proven, repeatable product you must endure the most rigorous of design and testing processes and in these new dynamometer test stands we have that.”


Cox explained that the pair of testing units are in addition to a thruster dyno test bed at North American headquarters in Flemington, New Jersey, where prospective and existing customers can see six of the company’s most popular brakes and couplings undergo thorough examination. The system is also used for in-house training and employee inductions.


Back in Germany, where the testing centre runs under the watchful eye of Johannes Hammelrath, the new dynamometer test stands boast some staggering numbers. For example, the diameter of the test brake discs range from 560mm to 1200mm, depending on the test brake; the maximum braking torque (static and dynamic) is 30,000Nm; the maximum speed is 2200rpm; and the mass inertia is adjustable in steps from 50 to 1000kgm², via coupleable flywheel masses. Cox also pointed to the maximum energy (without brake disc) of 25,000 kJ at 2200rpm; and maximum braking performance of 3.5MW at 2200rpm and 30,000Nm.


He said, “Hundreds of our products have already been tested at this new centre. Typically, products are tested upon design of the units in production batches. We also are asked sometimes for proof testing; we can pair up a given disc with pads and burnish them in for a small fee and prove given torques – not just static paperwork.”


Author: PINTSCH BUBENZER USA LLC

Editor: Wingsi Zhou


[Disclaimer] This page is reproduced.  The purpose is to convey more information of the industry.   LET official website assumes no responsibility for any views or errors contained herein.  If the content of the work, copyright and other issues are involved, please contact us within 30 days, we will delete the content as soon as possible.


TAG:   LET - a CeMAT ASIA event